User Manual
3. You may optionally calibrate the EMD with a Temperature Offset (+ or - °C) or Humidity Offset (+
or percent). If you check Temperature in Fahrenheit, the temperature will be reported in
Fahrenheit. Otherwise it will be reported in degrees Celsius
4. Provide Labels for each of the alarm sensors e.g. Door Open or Smoke Alarm.
5. Check Log Status and specify the Log Rate (minutes between samples) if you wish the status
from this EMD to be logged. These logs can be views from the Status > Environmental Status
screen
6. Click Apply. This will also create a new managed device (with the same name)
7.3.4 Environmental alerts
Set temperature, humidity and probe status alerts using Alerts & Logging > Alerts
To Next Page
Loading...
Need help?
General
