28 Operation
FalconV User Manual - Standard Scanning - OPEX Corporation
Run screen buttons
Press Go to start the scanner.
The Page Type buttons indicate the page types assigned to the current
job. The use of the buttons varies depending on the job setup. See
“Assigning a page type” on page 67 for more information.
Rotate the image of the selected item. Use the three buttons to rotate
the image 90 degrees clockwise, 180 degrees clockwise, and front to
back.
Press the Filter button to show only those items that require editing
using CertainScan Edit.
Press this button to filter blank images from the Thumbnail view.
Adjust the settings in the Capture Parameters window to enhance the
quality of the output images, select an alternate track speed and
alternate DPI mode. See page 69.
Press a Rescan button to replace a previously scanned image with a
new one. This button will only be available if it has been activated in the
batch parameters. See “Rescanning items” on page 72.
Delete last item from end of batch or range of items to end of batch.
This is only available when the scanner is stopped. This button will only
be available if it has been activated in the batch parameters. See
“Deleting items from the batch” on page 77.
Void the selected item or set. This button will only be available if it has
been activated in the batch parameters.
Start a new Set. This button is only available if it has been activated in
the batch parameters.
Start a new Group. This button is only available if it has been activated
in the batch parameters.
Start a New Batch. This button will only be available if it has been
activated in the batch parameters.
Press the Action button to access the Rescan, New Batch, and Void
buttons. The Action button only appears if two or more of these buttons
(Rescan, New Batch, Void) are enabled.
To Next Page
Loading...
