62 Operation
FalconV User Manual - Standard Scanning - OPEX Corporation
MultiAssist
The MultiAssist tab appears if the job is set up to use the optional Multi-Slot
IdAssist feature, and displays graphical information regarding which slot, swipe
method, and action has been programmed for the job. See Figure 29 on
page 88.
Reference IDs
Shows the reference IDs defined for the running job. Not visible if reference IDs
are not defined. The values in this window indicate how subsequent items will
be noted. It also indicates how the batch will be noted. Since the RefIDs for a
batch are not finalized until the batch is closed, batch RefIDs may be changed
at any time. Page RefIDs, however, may only be changed by rescanning the
item in question.See the “CertainScan Advanced Features” manual for more
information on Reference ID.
ScanLink
This window is controlled by the ScanLink plug-in for the running job. This
window is not visible if a plug-in is not defined.
WholesaleWorks 0
This window is controlled by the ScanLink plug-in for the running job. This
window is visible if the plug-in requests it. This window is also labeled by the
plug-in.
WholesaleWorks 1
This window is controlled by the ScanLink plug-in for the running job. This
window is visible if the plug-in requests it. This window is also labeled by the
plug-in.
To Next Page
Loading...
