OPTICOM 764 - Page 11

To Next Page

To Previous Page

Intersection Equipment Installation Instructions

Figure 3-1. Radio Signal Pattern

1. Cable retainer 3. GPS antenna

2. Intersection radio/GPS unit 4. Radio antenna

Main Page

Default Chapter3
- Table of Contents3
1 About this Manual5
- Intended Use5
- Technical Support5
- Safety Messages and Safety Labels5
- Safety Considerations5
- Disposal of Device6
- FCC Statement6
2 Description7
3 Radio/Gps Unit Installation10
- Model 1010 Radio/Gps Unit Mounting Location Considerations10
  - Model 1010 Radio/Gps Unit Installation14
  - Model 1012 Radio Installation16
4 Powering the Phase Selector20
- Powering on 120 VAC 60 Hz20
- Powering on 24VDC20
5 Phase Selector Installation in Controller Cabinets with Existing Card Racks21
- Potential for Electrical Shock23
6 Phase Selector Installation in NEMA Cabinets Using 760 or 1040 Card Rack24
- Model 1045B Card Rack27
  - Model 1045 in IR Operation27
7 Model 755 Four Channel Adapter Card and Other Model Card Racks28
8 Radio/Gps Cable Connection29
9 Model 768 Auxiliary Interface Panel (AIP)30
- Auxiliary Interface Panel Installation31
- Green Sense Wiring33
- Confirmation Light Wiring34
  - Confirmation Light Wiring with Load Switch Interface34
  - Confirmation Light Wiring with Electromechanical Relay Interface36
- Connecting Existing Harnesses to the Model 768 Auxiliary Interface Panel38
- Additional Output Connections39
  - Turn Signal Dependant Operation Example42
10 Infrared (IR) Operation43
11 Phase Selector Pin Index44
12 Communication Ports46
- Ethernet Port46
  - Ethernet Indicators46
- USB Port47
- RS-232 Communication Ports47
  - RS-232 COM Port on the Rear Edge Connector49
  - RS-232 COM Ports on the Auxiliary Interface Panel50
13 Phase Selector Indicators, Display and Switches51
- Indicators51
- Display and Switches53
14 Checkout58
15 Troubleshooting58
- Fuse Locations58
- Troubleshooting Tables59
16 Maintenance63
17 Setup and Testing63
Appendix A: Opticom Output Connection Worksheet (High Priority Only)64
Appendix A1: Opticom Output Connection Worksheet (High & Low Priority)65
Appendix B: Driving a Relay from a Phase Selector66
Appendix C Gate Opener Card Rack68
- Gate Opener Card Rack Installation69
  - Gate Opener Relay Outputs71

OPTICOM 764 - Page 11

Table of Contents