Opticon OPR 3201 - Tilt of Laser Scan Line; Curvature of Scan

Opticon
OPR 3201
Specifications Manual
13
Refer to chapter 8, “Technical Specifications,” to read about scanning performance.
7.1.1.
Tilt of Laser Scan Line
Laser scanning tilt is the vertical difference between both ends of a laser scan
line. Measure it in the middle of the laser scan line.
• Up to 0.92° angle in vertical direction from the scan origin (mirror motor).
• Up to 2.46 mm when measured at a point 150 mm from the scan origin.
7.1.2.
Curvature of Scan
The maximum difference between the laser scan line and the line between both
ends of the laser scan line. Measure it in the middle of the laser scan line.
• Up to 1.27° angle in vertical direction from the scan origin (mirror motor).
• Up to 3.3 mm curvature when measured at a point 150 mm away from the
scan origin.
Figure 5: Laser scan tilt and curvature