Opticon OPR 3201 - Figure 14: Cannot Receive Command; Figure 15: Signal Timing

Opticon
OPR 3201
Specifications Manual
21
within a specified period. The Flow Control time-outs are as follows, and the
default setting is “indefinitely“ (I0).
Flow Control Time Out Menu/Command
Indefinitely I0
100 ms I1
200 ms I2
400 ms I3
Figure 14: Cannot receive command
CTS, TXD signal timing
When the CTS line (RTS signal of the host) is turned OFF while sending a TXD signal,
the scanner transmits one character and waits. When the CTS signal is turned ON while
transmitting a character, the character will be transmitted.
Figure 15: Signal timing
Note: When using loopback (wire connection) for RTS, CTS line of the scanner in this
setting, No handshake is not enabled.