Opticon OPR 3201 - USB-HID and USB-VCP Interface Specifications; Settings; Interface Circuit; Wedge Interface Specification

Opticon
OPR 3201
Specifications Manual
25
9.2. USB-HID and USB-VCP Interface Specifications
9.2.1. Settings
Reading the menu barcodes in section 11.1 can set the USB interface default.
The interface is full-speed USB, 12 Mbps (HID/VCP) and low-power bus-powered.
For USB-VCP support, a driver must be installed on the host.
9.2.2.
Interface Circuit
Figure 19: Interface circuit
Do not use the keyboard while the scanner is transmitting the data to the host.
Doing so may cause data transactions to fail.
9.3. Wedge Interface Specification
9.3.1. Settings
Reading the menu barcodes in section 11.1 can set the Wedge interface default.