Opticon
OPR 3201
Specifications Manual
39
14.7. Cable Bending Test
No malfunction occurred after the following cable bending test.
Add a load of 4.9 N (500 gf) to a cable then bend it at an angle of 90 degrees to both right
and left. Repeat this bending test for 1 million times.
4.9N(500gf)
4.9N(500gf)
4.9N(500gf)
Figure 32: Cable bending test
15. Reliability
MTBF (Mean Time Between Failures) of this product is 10,000 hours.
The estimate of MTBF and product life cycle is based on standard operation of the product
within the recommended temperature range and without extreme electronic or mechanical
shock.
To Next Page
Loading...
