4. LNB Power: Press the VOL+/VOL- button to select the required LNB power.
5. 22kHz: Press the VOL+/VOL- button to select ON, OFF or Auto.
6. DiSEqC 1.0: Press the VOL+/VOL- button to select the required DiSEqC1.0
input.
7. DiSEqC 1.1: Press the VOL+/VOL- button to select the required DiSEqC1.1
input.
8. Motor: Press the VOL+/VOL- button to select DiSEqC1.2 or USALS motor.
9.Scan Mode: : Press the VOL+/VOL- button to choose available scan options: All
Channels/FTA channels/HD channels/ SD channels/ TV channels/ Radio
channels/ FTA TV channels/ FTA Radio channels/
10. Start search: Press the VOL+/VOL- button to select Satellite & Multi-Sat &
Blind scan & Transponder & Multi-Transponder which you want to start search.
4.2.1 Antenna Settings for Satellite
Move cursor to Satellite position. Press OK button. You can see the pre-stored
Satellite list. In this menu, you can execute Select, Add, Move, Delete, Rename
Satellites by pressing VOL+/VOL- button.
Select
In this menu, you can press the CH+/CH- keys choose the satellite which you want
to use, and then press the OK to confirm the setting.
Add
Select the Add using the VOL+/VOL-
keys. Here you can input new Satellite
angle, Satellite Direction (East, West),
Band (Ku, C). Press OK to confirm the
setting and this new satellite will be
added to the end of the Satellite list.
Move
To Next Page
Loading...
