Optimum OptiDrill DH45V - User Positions; Safety Measures During Operation

Safety
Version 1.0.2 dated 2018-03-02 Page 12 Translation of the original instructions
DH45VGB
DH45V_GB_1.fm
OPTIMUM
MASCHINEN - GERMANY
®
 instruct the personnel in regular intervals (at least once a year) on
- all safety regulations relevant to the machine,
- its operation and
- generally accepted engineering standards.
 check the personnel‘s knowledge level,
 document the training/instruction,
 have attendance at the training/instruction confirmed by signature and
 check whether the personnel is working in a safety and risk-conscious manner and follow-
ing the operating instructions.
 define and document the inspection deadlines for the machine in accordance with § 3 of the
Factory Safety Act and perform an operational risk analysis in accordance with § 6 of the
Work Safety Act.
Obligations of the operator
 have obtained a training regarding the handling of the geared drill,
 know the function and mode of action,
 before taking the machine in operation
- have read and understood the operating manual,
- be familiar with all safety devices and instructions.
Additional
requirements
regarding the
qualification
Additional requirements apply for work on the following machine components:
 Electrical parts or operating agents: shall only be performed by an electrician or under the
guidance and supervision of an electrician.
 Before starting work on electrical parts or operating agents, the following actions must be
taken in the order given:
 disconnect all poles,
 secure against restarting,
 check that there is no voltage.
1.7 User positions
The operator position is in front of the geared drill.
1.8 Safety measures during operation
CAUTION!
Danger due to inhaling dust and mist that are hazardous to health.
Depending on the materials to be machined and the agents used, dusts and mists can
arise that are detrimental to health.
Ensure that the harmful dust and mist generated are safely sucked off at the point of
origin and routed away from the working area or filtered. To do so, use a suitable
extraction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Extra precautionary measures must be taken before machining flammable materials (e.g.
aluminium, magnesium) or using combustible agents (e.g. spirit) to avert a health
hazard.