Maintenance
Version 1.0.2 dated 2018-03-02 Page 41Translation of the original instructions
DH45V GB
DH45V_GB_6.fm
OPTIMUM
MASCHINEN - GERMANY
®
WARNING!
Before starting the machine you must be sure that
no dangers generated for persons,
the machine is not damaged.
3.2 Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con
-
ditions.
Interval Where? What? How?
Start of shift
After each
maintenance or
repair work
Geared drill
Examination for outside damages.
"Safety check“ on page 13
Every month
Drill column and toothed rack
Oiling
Lubricate the drill column regularly with commercial oil,
machine oil, engine oil.
Lubricate the toothed rod regularly with commercial grease
(e.g. friction bearing grease).
Every month
Oiler cup
Oiling
Lubricate all oiler cups (height adjustment drilling table) with
machine oil, do not use grease guns or the like.
"Operating material“ on page 19
To Next Page
Loading...
