Maintenance
Version 1.0.2 dated 2018-03-02 Page 42 Translation of the original instructions
DH45VGB
DH45V_GB_6.fm
OPTIMUM
MASCHINEN - GERMANY
®
the first time after 200 hours of operation,
then every 2000 hours
Gear
Refilling oil
Oil change
For oil change use an appropriate collecting tray of sufficient
capacity.
Remove the filler hole plug.
Remove the oil drain plug.
If necessary use sealing tape for drain plug.
Fill in the open lubricating system of the geared drill about 3
litres of oil.
Check if the oil level is correct via the sight glass. The sight
glass (oil level dropped) must be half covered.
Img. 3-1: Gear oil level
Interval Where? What? How?
Filler hole
Sight glas, oil
level dropped
Oil outlet
To Next Page
Loading...
