Safety
Version 1.0.2 dated 2018-03-02 Page 14 Translation of the original instructions
DH45VGB
DH45V_GB_1.fm
OPTIMUM
MASCHINEN - GERMANY
®
1.11 Emergency stop button
CAUTION!
The drilling spindle keeps turning for a short time even after actuating the emergency
stop push button depending on the preset speed.
1.11.1 Master switch
In the "0" position, the lockable main switch can be secured against accidental or non-author-
ised switching on by means of a padlock.
The power supply is cut off when the master switch is in the off position.
Except for the areas marked by the pictogram in the margin. In these areas there might be volt-
age, even if the main switch is switched-off.
WARNING!
Dangerous voltage even if the main switch is switched off.
The areas marked by the pictogram might contain live parts, even if the master switch is
switched off.
1.11.2 Drill chuck guard
Adjust the guard to the correct height before you start working.
To do so, slacken the clamping screw, set the required height and re-tighten the clamping
screw.
There is a switch integrated in the spindle protection mounting which monitors the closed posi-
tion.
INFORMATION
The machine cannot be started, if the drill chuck guard is not closed and the locking pin
of integrated drill drift is in drifting position.
Signs,
Markers
Installed and legible
Functional check
Equipment Check OK
Emergency stop button After the emergency stop button is pressed, the drilling
machine must switch off.
Drill chuck guard The drilling machine may only switch on, if the drill chuck
guard is closed. The engine must switch off when the drill
chuck guard is opened during operation.
Date: Checked by (signature):
General check
Equipment Check OK
Date: Checked by (signature):
To Next Page
Loading...
