Safety
Version 1.0.2 dated 2018-03-02 Page 13Translation of the original instructions
DH45V GB
DH45V_GB_1.fm
OPTIMUM
MASCHINEN - GERMANY
®
1.9 Safety devices
Use the geared drill only with properly functioning safety devices.
Stop the geared drill immediately, if a safety device fails or is faulty or becomes ineffective.
It is your responsibility!
If a safety device has been activated or has failed, the geared drill must only be used if you
the cause of the fault has been eliminated,
you have verified that there is no danger to personnel or objects.
WARNING!
If you bypass, remove or deactivate a safety device in any other way, you are
endangering yourself and other personnel working with the geared drill. The possible
consequences are
injuries due to components or workpieces flying off at high speed,
contact with rotating parts,
fatal electrocution,
The geared drill includes the following safety devices:
an emergency stop push button,
a drilling table with T-slots to fix the workpiece or a vice,
a drill chuck guard, in order to prevent interference with the rotating tool.
INFORMATION
The machine cannot be started, if the drill chuck guard is not closed and the locking pin
of integrated drill drift is in drifting position.
WARNING!
Although the isolating safety devices provided and delivered with the machine are
designed to reduce the risks of workpieces being ejected or parts of tools or workpieces
breaking off, they cannot eliminate these risks completely. Always work carefully and
observe the limits of the machining process.
1.10 Safety check
Check the geared drill before each start-up or at least once per shift. Inform the person respon-
sible immediately of any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
once a week (with the machine in operation) and
after all maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the geared drill
are legible (clean them, if necessary)
are complete (replace if necessary).
INFORMATION
Organise the checks according to the following table;
General check
Equipment Check OK
Guards Mounted, firmly bolted and not damaged
Date: Checked by (signature):
To Next Page
Loading...
