Appendix
Version 1.0.2 dated 2018-03-02 Page 69Translation of the original instructions
DH45V GB
DH45V_GB_9.fm
OPTIMUM
MASCHINEN - GERMANY
®
6 Appendix
6.1 Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
6.2 Terminology/Glossary
6.3 Change information operating manual
Term Explanation
Drill drift Tool to release the bit or the drill chuck from the drill spindle
Drill chuck Drill bit adapter
Drill head Upper part of the geared drill
Drill sleeve Fixed hollow shaft which runs in the drill spindle.
Drilling spindle Shaft activated by the motor
Drilling table Supporting surface, clamping surface
Taper mandrel Cone of the drill or of the drill chuck
Spindle sleeve lever Manual operation for the drill feed
Quick-action drill chuck Drill holding fixture to be clamped manually.
Workpiece Part to be drilled, part to be machined.
Tool Drill bit, countersink, etc.
Chapter Short summary new version number
4.3.1 / 7 Information drilling depth, switching points 1.0.1
1 EMC categories 1.0.2
To Next Page