OPTIMUM
MASCHINEN - GERMANY
Version 1.1.6 dated 2014-10-16 Page 103Original operating instructions
F150 GB
10.4.8 Refill central lubrication system
The central lubrication system supplies important functionally parts of the CNC machine. With
too low level warning is the No. 700 162 .
Img.10-6: Central lubrication system
10.4.9 Fill up coolant
If the coolant level is lower than the red mark on the sight glass the amount of coolant to the
cutting tool is insufficient. Continuing the processing under such conditions leads to a reduced
service life of the cutting tool and reduces the life of the cooling lubricant pump.
Fill the coolant tank through the working area of CNC machine.
Img.10-7: coolant tank and chip pan
To Next Page
Loading...
Need help?
General
