Optimum OPTIMILL MF 2V - Default Chapter; Table of Contents

OPTIMUM
MASCHINEN - GERMANY
Version 1.3.0 dated 2016-12-16Page 2 Original operating instructions
MF2 VarioGB
Table of contents
1 Safety
1.1 Type plate.................................................................................................................................................4
1.2 Safety instructions (warning notes)...........................................................................................................5
1.2.1 Classification of hazards...........................................................................................................................5
1.2.2 Other pictograms ......................................................................................................................................5
1.3 Intended use.............................................................................................................................................6
1.4 Reasonably foreseeable misuses.............................................................................................................7
1.4.1 Avoiding misuses......................................................................................................................................7
1.5 Possible dangers caused by the milling-machine.....................................................................................8
1.6 Qualification of personnel .........................................................................................................................9
1.6.1 Target group .............................................................................................................................................9
1.6.2 Authorized personnel..............................................................................................................................10
1.7 Operator positions ..................................................................................................................................10
1.8 Safety devices ........................................................................................................................................10
1.8.1 Lockable main switch..............................................................................................................................11
1.8.2 EMERGENCY STOP push button..........................................................................................................11
1.8.3 Protective cover pulleys..........................................................................................................................11
1.8.4 Separating protective equipment............................................................................................................11
1.8.5 Milling table.............................................................................................................................................12
1.9 Prohibition, warning and mandatory labels.............................................................................................12
1.9.1 Control technical protection ...................................................................................................................12
1.9.2 Prohibition, warning and mandatory labels.............................................................................................12
1.10 Safety check ...........................................................................................................................................12
1.11 Personnel protective equipment .............................................................................................................13
1.12 Safety during operation...........................................................................................................................13
1.13 Safety during maintenance.....................................................................................................................14
1.14 Switching-off and securing the milling-machine......................................................................................14
1.14.1 Using lifting equipment ...........................................................................................................................15
1.14.2 Mechanical maintenance work ...............................................................................................................15
1.15 Accident report........................................................................................................................................15
1.16 Electrical system.....................................................................................................................................16
1.17 Inspection deadlines...............................................................................................................................16
1.18 Clamping devices for workpieces and tools............................................................................................16
2 Technical data
2.1 Electrical connection...............................................................................................................................17
2.2 Dimensions.............................................................................................................................................17
2.3 Milling capacity / removal........................................................................................................................17
2.4 Adjustment travels / swiveling range ......................................................................................................17
2.5 Speeds / feeds........................................................................................................................................18
2.6 Operating material ..................................................................................................................................18
2.7 Environmental conditions........................................................................................................................18
2.7.1 Emissions ...............................................................................................................................................18
3 Assembly
3.1 Scope of delivery ....................................................................................................................................20
3.2 Transport ................................................................................................................................................20
3.3 Load suspension point............................................................................................................................20
3.4 Installation and assembly .......................................................................................................................21
3.4.1 Installation site requirements..................................................................................................................21
3.4.2 Installation...............................................................................................................................................21
3.5 Fastening................................................................................................................................................22
3.6 First commissioning................................................................................................................................24