OPTIMUM
MASCHINEN - GERMANY
Version 1.3.0 dated 2016-12-16Page 20 Translation of the original instructions
MF2 VarioGB
MF2V_3_GB.fm
3 Assembly
INFORMATION
The milling machine is delivered pre-assembled.
3.1 Scope of delivery
Check the milling machine immediately after delivery for transport damage, missing parts and
loose locking bolts.
Compare the scope of delivery with the attached packing list.
3.2 Transport
WARNING!
Severe or fatal injuries may occur if parts of the machine tumble or fall down from the
forklift truck or from the transport vehicle. Follow the instructions and information on
the transport box.
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death. Check that the lifting and load suspension gear
has sufficient load-bearing capacity and that it is in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities applicable to your company.
Fasten the loads carefully.
Never walk under suspended loads!
3.3 Load suspension point
WARNING!
Check if all clamping screws of the spindle head carrier are tightened before lifting the
machine. see Img.4-12: “Moving the spindle head-holder forward or back“ on page 35.
Centres of gravity
(Marking of the positions for the load suspension
gear)
Prescribed transportation position (Labelling of
the top surface)
Means of transport to be used
Weights
To Next Page
Loading...
