OPTIMUM
MASCHINEN - GERMANY
Version 1.3.0 dated 2016-12-16Page 72 Original operating instructions
MF2 VarioGB
8 Appendix
8.1 Copyright
This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, neither partial nor total.
Subject to technical changes without notice.
8.2 Terminology/Glossary
8.3 Change information operating manual
Term Explanation
Cross table Bearing surface, clamping surface for the workpiece with X- and Y-
axis travel
Taper mandrel Cone of the drill or of the drill chuck
Workpiece Piece to be milled, drilled or machined.
Draw-in rod Threaded rod to fix the taper mandrel in the spindle sleeve.
Drill chuck Drill bit chuck
Collet chuck Holder for end mill
Drill-Mill head Upper part of the milling machine
Spindle sleeve Hollow shaft in which the milling spindle turns.
Milling spindle Shaft activated by the motor
Drilling table Supporting surface, clamping surface
Taper mandrel Cone of the drill or of the drill chuck
Spindle sleeve lever Manual operation for the drill feed
Quick action -
Drill chuck
Drill chuck can be fixed by hand.
Tool Milling cutter, drill bit, etc.
Chapter Short note new version number
CE EC declaration 1.2.7
CE EMC 2014/30/EU & LVD 2014/35/EU 1.2.8
1 Advanced information on inspection obligations 1.2.8
all DPA 2000 images replaced with DPA21 images 1.2.9
3 Notes on the circuit breaker 1.3.0
To Next Page
Loading...
