OPTIMUM
MASCHINEN - GERMANY
Version 1.3.0 dated 2016-12-16Page 28 Original operating instructions
MF2 VarioGB
4.1.1 Control panel
Img.4-2: Control panel
4.1.2 Safety devices
The machine has the following safety devices:
EMERGENCY-STOP push button
a separating protective device on the milling spindle,
4.1.3 Separating protective equipment
Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and re-tighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that
the cover is closed.
INFORMATION
You cannot start the machine if the spin-
dle protection is not closed.
Img.4-3: Separating protective equipment
Digital position display
DPA 21
ON/OFF switch
Control panel
Speed control
Spindle
Spindle Left - Stop -
Right selector
ON/OFF switch
Cooling lubricant
EMERGENCY-STOP
button
Separating
protective
equipment
To Next Page
Loading...
