Optimum OPTIMILL MF 2V - Raising; Lowering the Cross Table

OPTIMUM
MASCHINEN - GERMANY
Version 1.3.0 dated 2016-12-16 Page 31Original operating instructions
MF2 Vario GB
Img.4-5: Main switch
4.5 Raising / lowering the cross table
 You can raise or lower the cross table using the crank handle.
 Loosen the tightening lever.
 Engage the handle by pushing it towards the teeth.
 Turn the handle to the required position for the cross table.
 The scale has a graduation of 0.2 mm. The zero point can be adjusted using the knurled
nut.
 Clamp if needed.
 Make sure to tighten the tightening lever again once you have completed the operation.
Img.4-6: Cross table - height adjustment
Crank handle