Oracle Database Appliance X6-2-HA User Manual

Remove PCIe Card From PCIe Riser
AppendixA • Servicing the Oracle Database Appliance Version 1 149
b.
Remove the server node from the system.
Power is removed from the server node when you remove it from the system. See
“Removing Server Nodes From the System Chassis” on page 113.
c.
Remove the server node top cover.
See “Removing the Server Node Top Cover” on page 114.
2.
Locate the PCIe card in the PCIe riser that you want to remove.
See the "Oracle Database Appliance Version 1 Back Panel" section of the Oracle Database
Owner's Guide for the location of the PCIe slots.
3.
If necessary, make a note of where the PCIe cards are installed.
4.
Disconnect all data cables from the PCIe card.
To disconnect a cable from the PCIe card, press the latch, push in toward the connector, and
then pull out to remove the cable.
Note the location of all cables for reinstallation later.
5.
Remove the PCIe riser.
See “Remove PCIe Riser From Server Nodes” on page 144.
6.
Remove the PCIe card from the riser.

Oracle Database Appliance X6-2-HA Specifications

General

Brand	Oracle
Model	Database Appliance X6-2-HA
Category	Storage
Language	English