Powering On an Oracle Database Appliance That Includes a Storage Shelf
Chapter6 • Returning Oracle Database Appliance to Operation 95
Powering On an Oracle Database Appliance That Includes a
Storage Shelf
This section describes how to restore power after servicing an Oracle Database Appliance that
includes at least one storage shelf (DE2-24P, DE2-24C, or DE3-24C). If you have an Oracle
Database Appliance X6-2S/X6-2M/X6-2L or Oracle Database Appliance Version 1, your
system does not support a storage shelf and you should skip this section.
If you haven't already, return the Oracle Database Appliance to operational status. If you have
Oracle Database Appliance X6-2-HA, go to “Returning Oracle Database Appliance X6-2 Series
to Operation” on page 93. If you have Oracle Database X3-2, Oracle Database Appliance
X4-2, or Oracle Database Appliance X5-2, go to “Returning Oracle Database Appliance X3-2/
X4-2/X5-2 to Operation” on page 94.
When powering on the system, each server node is powered on separately.
Power On Procedure
Perform the following procedure to power on the Oracle Database Appliance.
1.
If you powered off and disconnected the power cords from a storage shelf (and
storage expansion shelf if one is present), reconnect the power cords now.
2.
Power on the storage shelf (and storage expansion shelf if one is present) by
switching the power supply On/Off button on each power supply to the On
position.
The disks begin to initialize and the power supply LEDs light green. This can take several
minutes.
Note - Do not power on the server nodes until the disks on the storage shelf and storage
expansion shelf have initialized.
3.
If you powered off a server node, reconnect any unplugged power cords.
4.
Power on a server node on using one of the following methods:
■
Press the recessed Power button on the server node front panel.
■
Log in to the Oracle ILOM web interface, click Host Management > Power Control, and
select Power On from the Select Action list box.
■
Log in to the Oracle ILOM command-line interface (CLI), and type the following command
at the Oracle ILOM CLI prompt.
To Next Page
Loading...
Need help?
General