Oracle Database Appliance X6-2-HA

Access BIOS Setup Utility Menus
AppendixA • Servicing the Oracle Database Appliance Version 1 231
The following procedure describes the steps for accessing the BIOS Setup Utility menus.
Access BIOS Setup Utility Menus
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
1.
Power-on or power-cycle the server node.
2.
The following information appears on the screen:
3.
To enter the BIOS Setup Utility, do the following:
a.
Wait for the last line of the screen output to change to Initializing USB
Controllers..Done
This will take several seconds.
b.
When Done appears, press the F2 key immediately.
Note - If there is an error during the boot process, you can press F1 to access the BIOS Setup
Utility.