Oracle Database Appliance X6-2-HA User Manual

Remove Boot Disk Backplane
AppendixA • Servicing the Oracle Database Appliance Version 1 169
c.
To clear the fault, type the following command:
-> set /SYS/MB/Pn clear_fault_action=true
For example, to clear a fault on P0:
-> set /SYS/MB/P0 clear_fault_action=true
Are you sure you want to clear /SYS/MB/P0 (y/n)? y
Set 'clear_fault_action' to 'true'
Servicing the Boot Disk Backplane (FRU)
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
The Oracle Database Appliance Version 1 boot disk backplane (BDB) serves as an interface
between the motherboard and the rear-mounted disk drives.
The boot disk backplane is a FRU and can only be replaced by an Oracle-qualified service
technician.
Caution - Equipment damage. These procedures require that you handle components that are
sensitive to static discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow antistatic practices as described in “Performing Electrostatic Discharge
and Antistatic Prevention Measures” on page 112.
This section includes:
■
“Remove Boot Disk Backplane” on page 169
■
“Install Boot Disk Backplane” on page 171
Remove Boot Disk Backplane
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing the boot disk backplane from Oracle Database Appliance
Version 1.

Oracle Database Appliance X6-2-HA Specifications

General

Brand	Oracle
Model	Database Appliance X6-2-HA
Category	Storage
Language	English