Oracle Database Appliance X6-2-HA User Manual

Install PCIe Riser in Server Nodes
AppendixA • Servicing the Oracle Database Appliance Version 1 147
b.
Install the server node into the system.
See “Installing a Server Node Into the System Chassis” on page 208.
c.
Reconnect any data cables to the PCIe card connectors on the system rear
panel.
d.
Power on the server node.
See “Powering On Oracle Database Appliance Version 1” on page 210.
4.
Clear PCIe riser faults.
a.
Log in to the Oracle ILOM CLI as root.
b.
Type:
-> show /SP/faultmgmt
Oracle ILOM lists all known faults. For example:
SP/faultmgmt
Targets:
0 (/SYS/MB/RISER)
Properties:
Commands:
cd
show
c.
To clear PCIe riser faults, use the set command. For example:
-> set /SYS/MB/RISER clear_fault_action=true
Are you sure you want to clear /SYS/MB/RISER (y/n)? y
Set 'clear_fault_action' to 'true'
Servicing PCIe Cards (CRU)
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes servicing PCIe cards in Oracle Database Appliance Version 1.
■
“PCIe Card Configuration” on page 148
■
“Remove PCIe Card From PCIe Riser” on page 148

Oracle Database Appliance X6-2-HA Specifications

General

Brand	Oracle
Model	Database Appliance X6-2-HA
Category	Storage
Language	English