Install Primary HBA PCIe Card in Motherboard
156 Oracle Database Appliance Service Manual • June 2017
3.
Return the server node to operation.
a.
Install the server node top cover.
See “Install Server Node Top Cover” on page 207.
b.
Install the server node into the system.
See “Install Server Node Into System Chassis” on page 208.
c.
Power on the server node.
See “Powering On Oracle Database Appliance Version 1” on page 210.
4.
Clear the primary HBA card fault.
a.
Log in to the server node as root using the Oracle ILOM CLI.
b.
To view server node faults, type the following command to list all known
faults on the server node:
-> show /SP/faultmgmt
Oracle ILOM lists all known faults, for example:
SP/faultmgmt
Targets:
0 (/SYS/MB/HBA)
Properties:
Commands:
cd
show
c.
To clear the internal PCIe card fault, use the set command. For example:
-> set /SYS/MB/HBA clear_fault_action=true
Are you sure you want to clear /SYS/MB/HBA (y/n)? y
Set 'clear_fault_action' to 'true'
Servicing the Server Node Battery (CRU)
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
The Oracle Database Appliance Version 1 battery maintains the date and time for the Oracle
ILOM service processor when the server node is removed from the system and, therefore, is
To Next Page
Loading...
Need help?
General