Oracle Database Appliance X6-2-HA User Manual

Install Boot Disk Backplane Cables
AppendixA • Servicing the Oracle Database Appliance Version 1 201
a.
Attach an antistatic wrist strap.
See “Performing Electrostatic Discharge and Antistatic Prevention
Measures” on page 112.
b.
Remove the server node from the system.
Power is removed from the server node when you remove it from the system. See
“Removing Server Nodes From the System Chassis” on page 113.
c.
Remove the server node top cover.
See “Removing the Server Node Top Cover” on page 114.
2.
Disconnect the power cable and hard disk drive (HDD) cables and remove them
from the server node.
a.
Disconnect the power cable and HDD cables from the motherboard [1].
b.
Disconnect the power cable and HDD cables from the boot disk backplane
[2].
Install Boot Disk Backplane Cables
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.

Oracle Database Appliance X6-2-HA Specifications

General

Brand	Oracle
Model	Database Appliance X6-2-HA
Category	Storage
Language	English