Install Mounting Brackets Onto the Server
4.
If there are leveling feet beneath the rack to prevent it from rolling, extend these
leveling feet fully downward to the floor.
Related Information
■
Rack documentation
■
SPARC S7-2 Server Safety and Compliance Guide
■
“Rack Compatibility” on page 26
■
“Rack Cautions” on page 27
Install Mounting Brackets Onto the Server
1.
Position a mounting bracket against the chassis so that the slide-rail lock is
at the server front, and the five keyhole openings on the mounting bracket are
aligned with the five locating pins on the side of the chassis.
30 SPARC S7-2 Server Installation Guide • July 2016
To Next Page
Loading...
