Assigning a Static IP Address to the SP
For more information, refer to the Oracle Solaris installation guide that corresponds to your
desired release and installation method.
Installing Oracle Solaris 11 Systems, comparing installation options at:
http://www.oracle.com/goto/solaris11/docs
For a list of valid boot commands that you can enter at the OpenBoot prompt, type:
{0} ok help boot
boot <specifier> ( -- ) boot kernel ( default ) or other file
Examples:
boot - boot kernel from default device.
Factory default is to boot
from DISK if present, otherwise from NET.
boot net - boot kernel from network
boot cdrom - boot kernel from CD-ROM
boot disk1:h - boot from disk1 partition h
boot tape - boot default file from tape
boot disk myunix -as - boot myunix from disk with flags "-as"
dload <filename> ( addr -- ) debug load of file over network at address
Examples:
4000 dload /export/root/foo/test
?go - if executable program, execute it
or if Forth program, compile it
Related Information
■
“Configure the Preinstalled Oracle Solaris OS” on page 60
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 61
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 63
■
“Assign a Static IP Address to the NET MGT Port” on page 67
Assigning a Static IP Address to the SP
If your network does not use DHCP, the NET MGT port is not operational until you configure
network settings for the service processor.
Note - If you are unable to use DHCP on your network, you must connect to the Oracle ILOM
on the SP using the SER MGT port to configure the NET MGT port for your network. See
“Assign a Static IP Address to the NET MGT Port” on page 67.
■
“Log In to the SP (SER MGT Port)” on page 66
Powering On the Server for the First Time 65
To Next Page
Loading...
Need help?
General