Note:
If you are installing clustered controllers, it is strongly recommended that you use
the BUI for initial configuration.
For clustered controllers, configure only the primary controller. Do not attempt initial
configuration on both controllers independently. For more information about clustering, see
Appliance Cluster Configuration in Oracle ZFS Storage Appliance Administration Guide,
Release OS8.8.x.
Before You Begin
• Gather the following information for the interfaces and services you will set up, and
network configuration details.
Note:
LDAP and NIS are optional for setup, but recommended. LDAP is preferred to
NIS; do not run NIS and LDAP at the same time.
– Default router IP address
– IP address and netmask for the management interface (two if clustered controllers)
– IP address and netmask for the data interface (two if clustered controllers)
– DNS/NIS/LDAP domain name
– DNS IP address(es)
– NIS server IP address(es)
– NTP server IP address
– For LDAP:
* LDAP server IP addresses
* Base search domain name
* Recursive or non-recursive search
* Authentication method: anonymous, self, or proxy (specific user)
* SSL/TLS usage
• You can skip any or all configuration screens by clicking COMMIT without making any
changes. For the final and registration step, click LATER if you want to complete the
screen later. To return to the beginning of the configuration utility, go to Maintenance:
System and click INITIAL SETUP.
1. Ensure you have configured the system as described in Configuring the System.
2. Direct your browser to the appliance using either the IP address or host name you
assigned during system configuration as follows:
https://ipaddress:215 or https://hostname:215
The login screen appears.
Chapter 13
Performing Initial Configuration (BUI)
13-5
To Next Page
Loading...
Need help?
General
