Note:
The slide rails can be used with either 9.5-mm square or M6 round mounting
hole racks.
3. If installing the assembly with cage nuts and mounting screws, insert the cage nuts into
the front and rear rack posts in the desired positions. Then insert the mounting screws
through the front and rear slide-rail brackets and rack posts.
4. Repeat steps 1 through 3 for the other slide-rail assembly.
Installing an Oracle ZFS Storage ZS9-2 Controller onto the
Rack Slide Rails
Use the following procedure to install an Oracle ZFS Storage ZS9-2 controller onto the rack
slide rails.
Caution:
This procedure requires a minimum of two people, or a mechanical lift, because of
the weight of the chassis. Attempting this procedure alone could result in equipment
damage or personal injury. Always load the heaviest equipment (disk shelves) at
the bottom of the rack.
1. If your rack includes an anti-tip foot, extend it from the bottom of the rack.
Chapter 4
Installing an Oracle ZFS Storage ZS9-2 Controller onto the Rack Slide Rails
4-3
To Next Page
Loading...
Need help?
General
