Orange Pi R1 Plus - SSH Remote Login to the Development Board; SSH Remote Login Development Board under Ubuntu

range Pi 用户手册 深圳市迅龙软件有限公司版权所有
www.orangepi.cn
34
www.xunlong.tv
^C
--- 192.168.2.1 ping statistics ---
4 packets transmitted, 4 received, 0% packet loss, time 3066ms
rtt min/avg/max/mdev = 0.390/0.439/0.473/0.034 ms
5) At this time, if the Wan port is connected to the Internet, the Ubuntu PC can also be
connected to the Internet
test@ubuntu:~# ping www.baidu.com
PING www.a.shifen.com (14.215.177.38) 56(84) bytes of data.
64 bytes from 14.215.177.38 (14.215.177.38): icmp_seq=1 ttl=55 time=7.32 ms
64 bytes from 14.215.177.38 (14.215.177.38): icmp_seq=2 ttl=55 time=7.72 ms
64 bytes from 14.215.177.38 (14.215.177.38): icmp_seq=3 ttl=55 time=7.80 ms
64 bytes from 14.215.177.38 (14.215.177.38): icmp_seq=4 ttl=55 time=7.05 ms
^C
--- www.a.shifen.com ping statistics ---
4 packets transmitted, 4 received, 0% packet loss, time 3005ms
rtt min/avg/max/mdev = 7.055/7.478/7.808/0.305 ms
3.5. SSH remote login to the development board
The OpenWRT system has SSH remote login enabled by default, and allows root
users to log in to the system. Before ssh login, you need to make sure that the Ethernet is
connected, and then use the ifconfig command or check the router to get the IP address of
the development board
3.5.1. SSH remote login development board under Ubuntu
1) Get the IP address of the development board
2) Then you can log in to the linux system remotely through the ssh command
test@test:~$ ssh root@192.168.1.87 (Need to be replaced with the IP address of
the development board)
3) The display after successfully logging in to the system is shown in the figure below