range Pi 用户手册 深圳市迅龙软件有限公司版权所有
www.orangepi.cn
59
www.xunlong.tv
4) The display after successfully logging in to the system is as shown in the figure below
5.8.
Onboard LED light test instructions
1） There are three LED lights on the development board, two yellow lights and one red
light. The default display of the LED lights when the system starts is as follows
Power status light (red
light)
The system starts, the red light flashes
Wan port status light
(yellow light)
Wan port is connected to the network cable, the yellow light is
always on, the Wan port is unplugged, the yellow light is off
Lan port status light
(yellow light)
The Lan port is connected to the network cable, the yellow
light is always on, and the Lan port is unplugged, the yellow
light is off
2
）
The method of setting the red light on and off and flashing is as follows
a) First enter the red light setting directory
root@orangepir1plus:~# cd /sys/class/leds/status_led
b) The command to set the red light off is as follows
To Next Page
Loading...
