range Pi 用户手册 深圳市迅龙软件有限公司版权所有
www.orangepi.cn
56
www.xunlong.tv
5.6.2.
Wan Port Test
1) First insert the network cable into the usb to Ethernet interface of the development
board, and make sure that the network is unblocked
2) After the system starts, it will automatically assign an IP address to the Ethernet
card through DHCP
3) The command to view the IP address is as follows
root@orangepir1plus:~# ifconfig eth0
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.1.62 netmask 255.255.255.0 broadcast 192.168.1.255
inet6 fe80::9db4:d13e:5e66:ee6a prefixlen 64 scopeid 0x20<link>
ether 66:2e:7d:b9:f7:74 txqueuelen 1000 (Ethernet)
RX packets 2055 bytes 150800 (150.8 KB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 145 bytes 13816 (13.8 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 29
4) The command to test network connectivity is as follows
root@orangepir1plus:~# ping www.baidu.com -I eth0
PING www.a.shifen.com (14.215.177.39) from 192.168.1.62 eth0: 56(84) bytes of data.
64 bytes from 14.215.177.39 (14.215.177.39): icmp_seq=2 ttl=56 time=6.51 ms
64 bytes from 14.215.177.39 (14.215.177.39): icmp_seq=3 ttl=56 time=6.45 ms
64 bytes from 14.215.177.39 (14.215.177.39): icmp_seq=4 ttl=56 time=6.44 ms
64 bytes from 14.215.177.39 (14.215.177.39): icmp_seq=5 ttl=56 time=6.59 ms
^C
--- www.a.shifen.com ping statistics ---
To Next Page
Loading...
