IGS-3032GC User’s Manual
63
5.1.11 Warning
Warning function is very important for managing switch. You can manage switch by
SYSLOG, E-MAIL, and Fault Relay. It helps you to monitor the switch status on remote site.
When events occurred, the warning message will send to your appointed server, E-MAIL, or
relay fault to switch panel.
5.1.11.1 Fault Alarm
When any selected fault event is happened, the Fault LED in switch panel will light up and
the electric relay will signal at the same time.
Fault Alarm interface
The following table describes the labels in this screen.
Label Description
Power Failure
Mark the blank of PWR 1 or PWR 2 to monitor.
Port Link Down/Broken
Mark the blank of port 1 to port 8 to monitor.
Apply
Click “Apply” to set the configurations.
Help
Show help file.
5.1.11.2 System Warning
System alarm support two warning mode: 1. SYSLOG. 2. E-MAIL. You can monitor switch
through selected system events.
System Warning – SYSLOG Setting
The SYSLOG is a protocol to transmit event notification messages across networks.
Please refer to RFC 3164 - The BSD SYSLOG Protocol
To Next Page
Loading...
