ORiNG IGS-3032GC - VLAN Commands Reference

IGS-3032GC User’s Manual
85
list separate by a
comma(ex.2, 3, 6)
[Workport]: The
amount of work ports,
this value could not be
less than zero or be
large than the amount
of member ports.
aggregator group
[GroupID] [Port-list]
nolacp
G
Assign a static trunk
group.
[GroupID] :1to3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
switch(config)#aggregator group 1
2-4 nolacp
or
switch(config)#aggreator group 1
3,1,2 nolacp
show aggregator P
Show the information
of trunk group
switch#show aggregator
no aggregator lacp
[GroupID]
G
Disable the LACP
function of trunk group
switch(config)#no aggreator lacp 1
no aggregator group
[GroupID]
G
Remove a trunk group switch(config)#no aggreator group 2
6.5 Commands Set List—VLAN command set
IGS-3032GC Commands Level Description Example
vlan database P
Enter VLAN configure
mode
switch#vlan database
vlan
[8021q | gvrp]
V
T
o set switch VLAN
mode.
switch(vlan)# vlanmode 8021q
or
switch(vlan)# vlanmode gvrp
no vlan
[VID]
V
Disable vlan group(by
V
ID)
switch(vlan)#no vlan 2