ORiNG IGS-3032GC - SNMP Commands Reference

IGS-3032GC User’s Manual
92
no snmp snmpv3-user
[User Name]
password
[Authentication
Password] [Privacy
Password]
G
Remove specified
user of SNMPv3
agent. Privacy
password could be
empty.
switch(config)# no snmp
snmpv3-user test01 password
AuthPW PrivPW
no snmp-server host
[Host-address]
G
Remove the SNMP
server host.
switch(config)#no snmp-server
192.168.10.50
6.11 Commands Set List—Port Mirroring command set
IGS-3032GC Commands Level Description Example
monitor rx G
Set RX destination
port of monitor
function
switch(config)#monitor rx
monitor tx G
Set TX destination
port of monitor
function
switch(config)#monitor tx
show monitor P
Show port monitor
information
switch#show monitor
monitor
[RX|TX|Both]
I
Configure source port
of monitor function
switch(config)#interface fastEthernet
2
switch(config-if)#monitor RX
show monitor I
Show port monitor
information
switch(config)#interface fastEthernet
2
switch(config-if)#show monitor
no monitor I
Disable source port of
monitor function
switch(config)#interface fastEthernet
2
switch(config-if)#no monitor
6.12 Commands Set List—802.1x command set
IGS-3032GC Commands Level Description Example
8021x enable G
Use the 802.1x global
configuration
command to enable
802.1x protocols.
switch(config)# 8021x enable
8021x system radiousip
[IP address]
G
Use the 802.1x
system radious IP
switch(config)# 8021x system
radiousip 192.168.1.1