ORiNG IGS-3032GC - Commands Set List-SNTP Command Set

IGS-3032GC User’s Manual
97
ring-topology-change
topology changed
event type
ring-topology-change
no event systemlog I
Disable port event for
system log
switch(config)#interface fastethernet
3
switch(config-if)#no event systemlog
no event smpt I
Disable port event for
SMTP
switch(config)#interface fastethernet
3
switch(config-if)#no event smtp
show systemlog P
Show system log
client & server
information
switch#show systemlog
6.15 Commands Set List—SNTP command set
IGS-3032GC Commands Level Description Example
sntp enable G
Enable SNTP function switch(config)#sntp enable
sntp daylight G
Enable daylight saving
time, if SNTP function
is inactive, this
command can’t be
applied.
switch(config)#sntp daylight
sntp daylight-period
[Start time] [End time]
G
Set period of daylight
saving time, if SNTP
function is inactive,
this command can’t be
applied.
Parameter format:
[yyyymmdd-hh:mm]
switch(config)# sntp daylight-period
20060101-01:01 20060202-01-01
sntp daylight-offset
[Minute]
G
Set offset of daylight
saving time, if SNTP
function is inactive,
this command can’t be
applied.
switch(config)#sntp daylight-offset 3
sntp ip
[IP]
G
Set SNTP server IP, if
SNTP function is
inactive, this
command can’t be
switch(config)#sntp ip 192.169.1.1