ORiNG IGS-3032GC - Commands Set List-Trunk Command Set

IGS-3032GC User’s Manual
84
the disable
form of this
command to
disable the
port.
show interface configuration I
show
interface
configuratio
n status
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
configuration
show interface status I
show
interface
actual status
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
status
show interface accounting I
show
interface
statistic
counter
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
accounting
no accounting I
Clear
interface
accounting
information
switch(config)#interface
fastEthernet 2
switch(config-if)#no accounting
6.4 Commands Set List—Trunk command set
IGS-3032GC Commands Level Description Example
aggregator priority
[1to65535]
G
Set port group system
priority
switch(config)#aggregator priority 22
aggregator activityport
[Port Numbers]
G
Set activity port switch(config)#aggregator
activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G
Assign a trunk group
with LACP active.
[GroupID] :1to3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
switch(config)#aggregator group 1
1-4 lacp workp 2
or
switch(config)#aggregator group 2
1,4,3 lacp workp 3