IGS-3032GC User’s Manual
88
specified
spanning-tree
instances. The
forwarding time
determines how long
each of the listening
and
learning states last
before the port begins
forwarding.
stp-path-cost
[1to200000000]
I
Use the spanning-tree
cost interface
configuration
command to set the
path cost for Spanning
Tree
Protocol (STP)
calculations. In the
event of a loop,
spanning tree
considers the path
cost when selecting
an interface to place
into the forwarding
state.
switch(config)#interface fastEthernet
2
switch(config-if)#stp-path-cost 20
stp-path-priority
[Port Priority]
I
Use the spanning-tree
port-priority interface
configuration
command to configure
a port priority that
is used when two
switches tie for
position as the root
switch.
switch(config)#interface fastEthernet
2
switch(config-if)# stp-path-priority
127
stp-admin-p2p
[Auto|True|False]
I
Admin P2P of STP
priority on this
interface.
switch(config)#interface fastEthernet
2
switch(config-if)# stp-admin-p2p
To Next Page
Loading...
