User’s Guide 12
6. Click “Finish”. You will see below screen, and then select ‘Yes.’ Now you can connect the
USB cable to the PC by following next section instructions.
Installing the Hardware
This section explains how to connect the cable modem to the computer, wall outlet, and
electrical outlet.
To install the hardware:
1. Power off the computer
2. Connect one end of the coaxial cable to the cable modem’s cable connector. Connect
the other end of the coaxial cable to the cable wall outlet. Be sure not to bend or over
tighten the cables as this may strain the connector and cause damage. If you plan to
connect the cable modem and television to the same wall outlet, you must use a cable
line splitter (not included).
3. Connect one end of the USB cable to the cable modem’s USB port and the other end of
the cable to the USB port on the PC.
4. Plug the cable modem’s power adapter into the cable modem’s power jack and into a
wall outlet or surge protector.
5. You are now ready to install the software drivers.
To Next Page
Loading...
General