User’s Guide 44
¾ dhcp domain-name set {domain name}
Set domain name manually.
¾ dhcp domain-name delete
Delete domain name manually assigned.
Interfaces
¾ interface ethernet address {ip address} mask {subnet netmask}{nat-private|””}
Set ethernet interface IP address.
Set ethernet interface IP address as nat-private gateway.
Example:
CM>interface ethernet address 192.168.100.1 mask 255.255.255.224
CM>show interface ethernet
Interface Ethernet
MAC address: 0002.8A0E.ECC8
IP address 192.168.100.1 subnet-mask 255.255.255.224
Link status: link
Mode: 100Mbps, full-duplex
Example:
CM>interface ethernet address 192.168.100.1 mask 255.255.255.224 nat-private
CM>show interface ethernet
Interface Ethernet
MAC address: 0002.8A0E.E673
IP address 192.168.100.1 subnet-mask 255.255.255.224 (nat-private)
Link status: link
Mode: 100Mbps, full-duplex
¾ interface ethernet dhcp-relay {ip address|enable|disable}
Enable/Disable/set ip address for ethernet interface for dhcp-relay.
¾ interface ethernet shutdown
Stop transmitting traffic on the ethernet interface
¾ interface ethernet startup
Start transmitting traffic on the ethernet interface
¾ interface cable upstream channel {id}
Set upstream channel ID
¾ interface cable downstream preset {frequency}
Add frequency to downstream frequency preset table
To Next Page
Loading...