User’s Guide 30
7. Telnet commands
The Cable Router telnet Login and Password:
Login:
Password:
** Note: Default Wireless LAN Cable Modem Router Telnet IP address is 192.168.100.1
Getting Help
Entering a question mark (?) at the system prompt displays a list of commands for each command
mode. To list keywords or arguments, enter a question mark (?) in place of a keyword or argument.
Include a space before the ?. This form of help is called command syntax help, because it reminds
you which keywords or arguments are applicable based on the command, keywords, and arguments
you already have entered.
CM>?
debug Debugging functions
undebug Disable debugging functions
image Image commands
ping Ping specified IP address
tracert Trace route
pwd Change password
user-level Change User's access right
show Show commands
nvram NVRAM command
tftp Display/Set TFTP information
host-name Host name command
dhcp NAT DHCP commands
nat NAT commands
interface Interface commands
ip IP commands
web-access Web access control command
access-list Access list command
pppoe-forwarding PPPoE forwarding command
firewall Config Firewall Check command
copy Copy command
cpe-limit Limit CPE number command
write Write configuratoin to nvram
reset Reboot Cable Modem
quit Disconnect
To Next Page
Loading...
General