Osram BT Series User Manual

OSRAM BT Control | Applications and settings
25
The following features are a selection of the most popular project-specific adaptations. There are also many additional
settings which can be looked up in the app.
Set the admin/user password
1 Open the main menu.
2 Open “Settings”.
3 Open “Password”.
4 Enter an admin password to
restrict the connection with the
OSRAM BT Config App.
Please note: When the admin pass-
word is empty, you can only connect
to the controller within
two hours after
connecting to mains.
To reconnect after
this time, you need to power-cycle the
controller.
5 Enter a user password to
restrict the connection with the
OSRAM BT Control App.
6 Enable “Lock user password”
to restrict the change of the user
pass-
word via the OSRAM BT Control App.
5.1.1.5 Password protection
When connecting to the OSRAM BT Config App for the first
time, a window pops up where an admin password and the
user password can be set.
If you want to add or change the password, follow steps below:
5.1.1.6 Switch-off delay time
The switch-off delay is the time after which the controller
will leave the “on-state”. The switch-off delay timer is retrig-
gered by each motion signal or manual user operation. The
light will go off when no standby level is activated.
Change the switch-off delay time
1 Open the main menu.
2 Open “Current configuration”.
3 Open “Motion detection” and go
to “Switch off delay”.
Change the switch-off delay time
according to your preferences.
2
1
3
4
5
6
2
1
3

Osram BT Series Specifications

General

Brand	Osram
Model	BT Series
Category	Control Systems
Language	English