OSRAM BT Control | Applications and settings
49
5.2.5.6 Change of default setup
The default setup of the control unit is the “Single Office”
mode, which needs to be changed to the “Open-plan office”
mode first.
Change of default setup
1. Open the main menu.
2. Open “Current configuration”.
3. The “Single office” profile is
activated by default.
4. Click on “Load a profile”.
5. Select the “Open-plan office”
profile and click on “OK” to save
this change of configuration.
5.2.5.7 Standby level and time
When the “Open-plan office” mode is activated (see chapter
5.2.5.6), the light will go to the pre-defined standby level of
30 % after the switch-off delay time has expired. The light
will switch off after one hour if no presence is detected during
the standby time.
Choose the standby level and time
1. Open the main menu.
2. Open “Current configuration”.
1. Open “Advanced settings”.
Choose the required “Standby level”
and “Standby time”.
Default values in “Open-plan office”
mode:
Standby level = 30 %
Standby time = 1 hour
2
1
2
1
3
4
5
3
To Next Page
Loading...
Need help?
General