4.16 User Preference System (UPS)
4.16.1 Overview
The User Preference System is the configuration utility of the STATUS 18R console. By
changing values in many of the LCD menus, the operating parameters of the console
can be changed to suit the Engineer. Current parameters that can be changed include:
• Switch Timeouts
• Solo Operation Upon Changing Modes
• Muted Channel Operation During a Solo
• Mode Blocking or Confirmation
• Path Tracking Mode
4.16.2 Saving UPS Settings
Modified UPS settings can be saved to the console’s internal disk. To save the UPS
settings:
1. Press Misc.
2. Press FILE then UPS.
3. Press SAVE.
The current UPS settings will overwrite those on disk.
4.16.3 Loading UPS Settings
To load UPS settings from disk:
1. Press Misc.
2. Press FILE then UPS.
3. Press LOAD.
The new UPS settings will be loaded from disk.
4.16.4 Reloading Factory Defaults
To reload the factory default UPS:
1. Press Misc.
2. Press FILE then UPS.
3. Press DFLTS.
Section 4 - Operation
August 1999 4 - 37
STATUS 18R Operation and Maintenance Manual
To Next Page
Loading...
Need help?
General