OTARI Status 18R User Manual

5.6.6 Setting End of Mix Processing
When writing the first pass of a new mix, it is only necessary to run a few seconds of the
mix to establish the basic levels of the mix. Eagle’s Mix Processing window lets you
decide how levels and switch states written during the mix affect data after time code
has stopped.
For the initial pass, set the end of mix processing as follows:
1. Click on the Windows menu and select Mix Processing.
2. Click on Write Changes To End of Mix.
While To End of Mix is in effect, written fader levels and switch states in effect when
time code stops will be written till the highest time code number and become the
basic levels of the mix.
NOTE: After writing the initial mix pass, you may want to set Mix Processing to End of
Time Code or To Next Change to prevent data from being overwritten.
Section 5 - Eagle Automation STATUS 18R Operation and Maintenance Manual
5 - 32
August 1999

OTARI Status 18R Specifications

General

Brand	OTARI
Model	Status 18R
Category	Music Mixer
Language	English