■ Auto Select
Pressing Auto Select puts the console in Auto Select mode. When any computer
controlled button is pressed on an Input module, that module becomes selected and is
attached to the Master Section for editing.
Auto Select only works in Copy To Master and One mode.
■ None Selected Indicator
The None Selected indicator lights when there are no modules selected. This can occur
when Copy To Master, Copy To Module or Set Transparent is pressed, or when a
selection is cancelled by a timeout.
Section 4 - Operation
August 1999 4 - 7
STATUS 18R Operation and Maintenance Manual
To Next Page
Loading...
Need help?
General