3. Press EQ In on the Mix path of module 22.
This causes the EQ In and EQ Out buttons in the Mix path area of the Master
Section to flash, indicating that the EQ In switches of the Selected modules are set
differently.
4. Press EQ In in the Mix path area of the Master Section.
This switches the EQ in on modules 22, 23 and 24. The EQ In and EQ Out buttons
on the Master Section stop flashing indicating that the EQ In states on the Selected
modules are the same.
Only the Master Section can have transparent switches. Transparent switches cannot be
copied to modules. This becomes important as you learn to copy the Master Section to
Input modules.
Section 4 - Operation
August 1999 4 - 9
STATUS 18R Operation and Maintenance Manual
To Next Page
Loading...
Need help?
General